3.3.13 MDI
Select "MDI" or press F7, to switch to the "MDI" dialog box, you can type more than one-block program. After pressing the F9 or Cycle Start button, the line where the cursor is located will be executed immediately. Be sure to pay attention to the safety on the machine side. Entering a one-line program on the MDI dialog box will be saved on the hard disk. When the dialog box opens, press the ↑ and ↓ keys to switch the cursor position and select the one-line program to be executed.
When the program encounters M00/M01 and suspends execution, MDI can temporarily input one-line program execution. However, in the case of tool radius compensation command, it will be stopped with M00/M01. In order to avoid affecting the original machining path of the program, any G code command of axial motion input by MDI will not be accepted and only G code of partial status change will be accepted instruction.