INCON-M84/M86/M86R Manual

1.

To activate HSHP for Mass Production function, set Speed Down Ratio value to 20 ~ 29 in HSHP mode.

2.

The PLC signals sts.mode2.mFastHSHPCat1 and sts.mode2.mFastHSHPCat2 will become 1 when this function is activated.

3.

The HSHP for Mass Production function is suitable for simple line and curve machining programs. The Acceleration is controlled by Feed Acceleration, and the G01 curve machining speed is controlled by Speed Down ratio. Smaller Speed Down ratio makes the curve machined slower and results in higher precision. Larger Speed Down ratio makes the curve machined faster and results in lower precision. Setting Speed Down ratio value to 25 at the start to test and then adjust the value based on machining condition.