3.2.7 Teach In
Select the "Teach In" item, a line of instructions will be inserted in the editor's cursor. The instruction will be taught according to the axis specified in the parameters to be taught. The values are respectively the program position values in each axis. For example, if the position of the program is (123.000, 100.120) and both axis specify the teaching, a line instruction such as X123.000 Y100.120 will be inserted in the program, and X123.000 if only X-axis teaching is specified.
While editing a machining program, you can use the panel to manually move the tool point by tapping the surface point of the original workpiece model, and press the Alt+T key at the same time to insert the current specified axis program position value into the program.
Note: |
The axis to be taught can be set by "F2→Parameter→Teach In Axis". |